C O M M E R C I A L
®
SANDBLASTER SBS
Commercial Gas Water Heaters
Sandblaster SBS Light-Duty Series
Recoveries – From 60 to 73 GPH, at 100°F Rise.
For applications where required first-hour delivery (at 100°F Rise)
is 142 gallons or less.
Self-Cleaning Design – Reduces sediment buildup, saves energy and money, prolongs tank life.
Low NOX – Complies with SCAQMD Rule 1146.2, Southern California and Texas approved.
Standing Pilot Ignition System.
Aluminized Steel Multi-Port Burner – For even heat distribution, maximum efficiency,
quiet operation.
Foam Insulation – Reduces heat loss over 2-1/2 times more effectively than standard fiberglass.
Factory-Installed Energy Cut-Off (“ECO”).
Anode Rod – protects glasslined tank against electrolytic
corrosion.
Tank Inspection Port – (Excludes SBS65 65NE).
Maximum Hydrostatic Working Pressure:
150 psi.
3 or 5-Year Tank Warranty –
With no “fine print”excluding sediment buildup.
SBS65 65NE
SBS75 76NE
SBS100 76NE
SBS65 65NE
SBS75 76NE & SBS100 76NE
BTU’S
First Hour
Delivery
Gallons
Recovery, Gallons
at Degree F Rise
Approx.
Per Hour
Dimensions in Inches
Shipping
Weight
(lbs.)
Gallon
Cap.
Natural or
Propane (LP) 100°F Rise
Gas
Conn.
Model Number
80° 100° 140°
A
B
C
D
E
F
G
H
J
K
65,0001
591⁄2
24
⁄2
251⁄2 541
⁄
4
⁄
4
⁄2
⁄2
⁄2
˝
˝
˝
215
275
350
1
3
1
SBS65 65NE
65
1
1
1
1
581⁄2 261⁄2 153⁄16
⁄2
⁄
2
505⁄8
1
SBS100 76NE
98
75,100
142
91
73
52 685⁄8 661⁄2 273⁄4 153⁄16 16
4
141⁄2 2911⁄16 573⁄8
11⁄4
All models available in Canada. When ordering, add “CGA” to model number (SBS75 76N CGA).
When ordering Propane, change “N” to “P” in model number (SBS75 76PE).
1 Propane rated 55,000 Btu.
All Sandblaster SBS Series water heaters are design-certified by CSA International or UL as Automatic Circulating, Automatic Instantaneous, or Automatic Storage water heaters. When used singly or in
manifolded multiples with additional heaters or storage tanks, they can provide an independent hot water system. When installed with a mixing valve, they can provide both 140°F general use hot water and
180°F sanitizing hot water simultaneously.
All models over 75,000 Btu input meet or exceed Federal Efficiency Requirements prescribed by the Energy Policy and Conservation Act of 1992 (EPACT) for Commercial Water Heaters. They also meet or
exceed the thermal efficiency and/or standby loss requirements of the U.S. Department of Energy and current edition of ASHRAE/IESNA 90.1.
For more information on Sandblaster® contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800-365-0024 Toll-free USA
SCGSS00107
August 2008R
|