B
C
D
A
1
2
3
4
5
Amplifier
SURROUND BACK
e
E
e
E
E
e
Micro Sa t e llit e Sp e a ke r
SS-V811ED/V521
e
Surround back
E
e
Foot pads
E
4-233-678-11(1)
En g lish
Su p p lie d a cce sso rie s
Fe a t u re s
Ho o kin g u p t h e sp e a ke r (A)
Po sit io n in g t h e sp e a ke rs
Pre ca u t io n s
Sp e cifica t io n s
Speaker stand (1) (SS-V811ED only)
Screws (2) (SS-V811ED only)
The instructions in this manual are for SS-V811ED and
SS-V521, Sony Micro Satellite Speaker.
Connect the speaker to the speaker output terminals of
an amplifier.
Make sure power to all components (included the
subwoofer) is turned off before starting the hook-up.
Lo ca t io n o f e a ch sp e a ke r
Washers (2) (SS-V811ED only)
Plate (1) (SS-V811ED only)
Foot pads (4) (SS-V521 only)
Speaker connecting cords, 10 m (32 ft 9 3/ 4 in.) (1)
On operation
SS-V811ED (SS-MS815)
• Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
• If the polarity of the speaker connections are not
correct, the bass tones will be weak and the position of
the various instruments obscure.
• Contact between bare speaker wires at the speaker
terminals may result in a short-circuit.
• Before connecting, turn off the amplifier to avoid
damaging the speaker system.
Center
Speaker system
2 way, magnetically
shielded
Tweeter: 1.9 cm (3/ 4 in.),
dome type
Woofer: 5 cm (2 in.) × 2,
balanced drive type
If you add this speaker to SA-VE815ED and SA-VE525,
you can enjoy the surround effect as a 6.1 channel
speaker system. Please refer to the manual provided for
SA-VE815ED and SA-VE525 when you connect this
speaker to the other speakers of SA-VE815ED and SA-
VE525.
Subwoofer
Speaker units
No t e s (B)
Front (Left)
Front (Right)
• Make sure the plus (+) and the minus (–) terminals on
the speakers are matched to the corresponding plus (+)
and minus (–) terminals on the amplifier.
• Be sure to tighten the screws of the speaker terminals
securely as loose screws may become a source of noise.
• Make sure all connections are firm. Contact between
bare speaker wires at the speaker terminals may cause
a short-circuit.
Design and specifications are subject to change without
notice.
Enclosure type
Rated impedance
Power handling capacity
Maximum input power:
Sensitivity level
Frequency range
Dimensions (w/ h/ d)
When attached speaker grille:
Bass reflex
8 ohms
Any difference in operation is clearly indicated in the
text, for example, “SS-V811ED only”.
140 W
87 dB (1 W, 1 m)
120 Hz - 70,000 Hz
Rear (Left)
Rear(Right)
If yo u e n co u n t e r co lo r irre g u la rit y o n a
n e a rb y TV scre e n
• For details regarding the connections on the amplifier
side, refer to the manual that was provided with your
amplifier.
Surround back
This speaker system is magnetically shielded to allow it
to be installed near a TV set. However, color
irregularities may still be observed on certain types of TV
sets.
Tip s
• Movies are best enjoyed in a room that produces no
echoes (as in one with surrounding curtains).
• Music (especially classical music) is best enjoyed in a
room that produces some echo.
Approx. 86 × 169 × 130
Tip
mm
All striped wires are minus (–) in polarity, and should be
connected to the minus (–) speaker terminals.
(3 1/ 2 × 6 3/ 4 × 5 1/ in.)
If co lo r irre g u la rit y is o b se rve d ...
8
c
Turn off the TV set once, then turn it on again after
15 to 30 minutes.
When attached to supplied speaker stand:
Approx. 96 × 207 × 141
mm
Po sit io n in g t h e sp e a ke r
If co lo r irre g u la rit y is o b se rve d a g a in ...
Place the speakers further away from the TV set.
7
(3
/
8 × 8 1/ 4 × 5 5/ 8 in.)
(fo r SS-V811ED o n ly) (C)
Attach the speaker to supplied speaker stand and place
them at their optimum locations.
For details on the location of the speaker, see “Location
of each speaker”.
c
Mass
When attached speaker grille:
If h o w lin g o ccu rs
Approx. 1.3 kg
(2 lb 14 oz)
Reposition the speakers or turn down the volume on the
amplifier.
When attached to supplied speaker stand:
Approx. 1.4 kg
On placement
• Do not set the speakers in an inclined position.
• Do not place the speakers in locations that are:
1
2
Detach the plate from the stand.
(3 lb 1 oz)
—
—
—
—
—
Extremely hot or cold
Dusty or dirty
Very humid
Subject to vibrations
Subject to direct sunlight
Pass the speaker cord into the hole on the
back of the stand and out from the hole at the
center of the stand.
SS-V521 (SS-MS525)
Speaker system
Full range × 2,
magnetically shielded
5 cm (2 in.), balance
type
Speaker units
drive
3
4
Separate the speaker cord, then secure the
cord to the speaker stand with the plate.
On cleaning
Enclosure type
Bass reflex
Clean the speaker cabinets with a soft cloth lightly
moistened with a mild detergent solution or water. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
Rated impedance
Power handling capacity
Maximum input power:
Sensitivity level
Frequency range
Dimensions (w/ h/ d)
8 ohms
Connect the speaker cord to the speaker
terminal.
120 watts
87 dB (1 W, 1 m)
120 Hz - 20,000 Hz
Approx. 89 × 144 ×
130 mm
The cord should be pressed into the groove
in the stand.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony dealer.
(3 5/ 8 × 5 3/ 4 × 5 1/ 8 in.),
including front grille
Approx. 750 g
5
Using the supplied screws and washers,
secure the speaker to the stand.
Mass
(1 lb 10 oz)
No t e
Do not remove the supplied speaker grille from the
speaker while attaching the speaker to the speaker stand.
Se t t in g t h e sp e a ke r
(fo r SS-V521 o n ly) (D)
To prevent speaker vibration or movement while
listening, attach the supplied foot pads to the speaker.
2001 Sony Corporation
Printed in China
|